Even if it costs hundreds of times as much as a normal nozzles.

If you want to completely eliminate the problem of abrasion, you can opt for a nozzle made with a ruby. Or maybe you could use hardened steel or even more resistant. To overcome this problem you can opt for a steel one, much more resistant to abrasion. Especially by filaments loaded with metals or carbon. The typical one is made of brass but this material is easily abraded. Nozzle could also made of different materials. We have dedicated an article to the cleaning of the nozzle and we propose it to you at this link. If you make a mistake it is very easy to shut it down and in any case must be cleaned and checked regularly. Repeat Steps 6 and 7 until all the colored lines are printed properly by your Epson 元150 printer. Examine the patterns again on the paper to see if there is an improvement in the quality. After this process, repeat the previous step (STEP 6). This component is one of the most problematic. Otherwise, you won’t be able to run the Head Cleaning process. At the same time, it avoids some problems that can be encountered if you go down with the measures.

Normally on commercial printers is installed by default a n ozzle of 0.4 mm. This because it allows you to print many details, rather quickly. A coarse piece, maybe cubic, we can use larger nozzles reducing the execution time. There are many different sizes, mainly ranging from 0.2 mm to 0.8 mm, depending on the type of print to be dealt with.Īn artistic print, very small and with many details we will prefer to print it with an exit hole of 0.3 mm. The difference that immediately catches the eye is the size of the exit hole of the material. You can find a lot of nozzles, with a lot of differences. That is, the deposit of the molten plastic is the nozzle. Nozzle plays the most difficult part, which we could biblically define the passage of the camel through the eye of a needle.

Ozzle print